• Step 1:

    • Place rear frame set between back support and front frame set.
    • Make sure linkage is facing the steering handle.
  • Step 2:

    • Align screws.
  • Step 3:

    • For models WITH push bar, tighten bolt only using allen wrench. Do not attach nut.
    • For models WITHOUT push bar, tighten bolt and nut using allen wrench and multi-purpose tool.
    • Reflector can be attached by inserting below frame before tightening nut.
  • Step 4:

    • Remove screws on the steering handle and align with steering handles.
    • Make sure brake cable is located above linkage.
  • Step 5:

    • Attach nut to bolt.
  • Step 6:

    • Tighten using allen wrench and fender tool.
  • Step 7:

    • (* For seat belt only - If your model does not have a seat belt, skip to Step 13)
    • Align bottom of seat belt to seat base on frame and bottom of seat.
  • Step 8:

    • (* For seat belt only)
    • Tighten bolt and repeat on other side.
  • Step 9:

    • (* For seat belt only)
    • Wrap top of seat belt over back support.
  • Step 10:

    • (* For seat belt only)
    • Wrap velcro strip around metal frame located below top cushions on back support.
  • Step 11:

    • (* For seat belt only)
    • Pull velcro strip through buckle.
  • Step 12:

    • (* For seat belt only)
    • Attach velcro.
  • Step 13:

    • Tighten seat cushion to seat base.
  • Step 14:

    • Adjust hand brake as needed,
    • Use allen wrench to tighten hand brake (located on steering handle).
  • Step 15:

    • Remove nut from wheel.
  • Step 16:

    • Insert wheel onto rear frame.
  • Step 17:

    • Use fender tool and allen wrench to tighten wheel.
    • Repeat on other side.
  • Step 18:

    • Remove chrome caps locate next to rear wheels.
  • Step 19:

    • Place fender above each wheel. Replace caps.
  • Step 20:

    • Tighten caps using fender tool.
  • Step 21:

    • Match the side of the pedals by matching the "L"/ "R" stickers on the pedals and cranks.
  • Step 22:

    • Attach pedal to crank.
    • Make sure to screw "R" pedal clockwise and "L" pedal counterclockwise.
  • Step 23:

    • Tighten using fender tool.
  • Step 24:

    • Loosen quick release lever located at the middle of cruiser.
    • Pull knob to adjust frame to desired length.
    • Tighten lever.
  • Step 25:

    • Insert flag into slot on top of back support.
  • Step 26:

    • (* For push bar only)
    • Align push bar under rear frame with bolts and tighten nut onto bolt.
  • Step 27:

    • (* For foot rest only)
    • Loosen and remove quick release lever.
  • Step 28:

    • (* For foot rest only)
    • Align foot rest onto frame, attach and tighten quick release lever.